Dimond Styleline Roofing

Dimond Styleline Roofing & Cladding

Suitable for 3° and greater

755mm Cover width

810mm Sheet width

Styleline has a low rib

Suitable for residential

Suitable for light commercial

Suitable for commercial

5 ribs per sheet

Styleline is manufactured in Whangarei, Auckland, Hamilton, Wellington and Christchurch.

If this product is not suitable for your project... Click here to find product options suitable for your requirements.

    • Suitable for 3° and greater

      755mm Cover width

      810mm Sheet width

      Styleline has a low rib

      Suitable for residential

      Suitable for light commercial

      Suitable for commercial

      5 ribs per sheet

      Styleline is manufactured in Whangarei, Auckland, Hamilton, Wellington and Christchurch.

      If this product is not suitable for your project... Click here to find product options suitable for your requirements.

Dimond Styleline Profile

Styleline has been specifically designed to produce contrasts of light and shade. Its stylish shape & the way it plays with light reflection means you only see the best from every angle, adding a contemporary look to your building. Perfectly suited for lower pitch roofs, it will set your project apart from the neighbours. 

Dimond Styleline Profile

Dimond Styleline Profile Dimensions

Cover

755mm

Sheet Width

810mm

Pitch

3° (approx 1:20)

all dimensions given are nominal

Sheet Tolerances

Sheet width: ±5mm
Sheet width for aluminium +0, -15. If sheet cover widths are critical, advise Dimond at time of order.
Sheet length: +10mm, –0mm. For horizontal wall cladding where notified at time of order of intended use, tighter tolerances can be achieved +3mm, –0mm

Profile Properties

Material options Steel 0.4mm Steel 0.55mm Aluminium 0.7mm Aluminium 0.9mm Duraclad 1.7mm (total thickness)
Nominal weight/lineal metre (kg/m) 3.17 4.27 1.78 2.28 2.2
Drape curved roof - min. radius (m) 80 40 80 40 12
Purlin spacings for drape curved roof (mm) (1) 1200 1400 1200 1400 1100
Machine crimp curved - roof min. radius (mm) 900 400 n/a 400 n/a
Unsupported overhang (2) 200 250 100 200 100

(1) Recommended maximum purlin spacing at minimum radius

(2) Based on 1.1kN point load support, but not intended for roof access.

n/a – not available

Roll-forming facilities

Whangarei, Auckland, Hamilton, Wellington, Christchurch

Crimp curving facilities

Whangarei, Auckland, Hamilton, Wellington, Christchurch

Manufacturing location for Duraclad

Auckland

Sheet lengths: Styleline is custom run to order. Where long sheets are used consideration must be given to:

  • special transportation licences for sheet lengths over 25m
  • site access for special lifting equipment
  • fixing techniques to accommodate thermal expansio
Sales Centres
Tech Support

Share to social media